linux輸入ifconfig找不到IP的解決辦法
阿新 • • 發佈:2020-09-20
關於輸入ifconfig命令沒有IP地址的問題
我在輸入ifconfig的時候沒有出現我的IP地址
最後我輸入sudo dhclient
然後輸入ifconfig就可以了
ens33: flags=4163<UP,BROADCAST,RUNNING,MULTICAST> mtu 1500 inet 192.168.17.129 netmask 255.255.255.0 broadcast 192.168.17.255 inet6 fe80::20c:29ff:feca:80ba prefixlen 64 scopeid 0x20<link> ether 00:0c:29:ca:80:ba txqueuelen 1000 (Ethernet) RX packets 389 bytes 28656 (27.9 KiB) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 93 bytes 20800 (20.3 KiB) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 lo: flags=73<UP,LOOPBACK,RUNNING> mtu 65536 inet 127.0.0.1 netmask 255.0.0.0 inet6 ::1 prefixlen 128 scopeid 0x10<host> loop txqueuelen 1000 (Local Loopback) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 virbr0: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 inet 192.168.122.1 netmask 255.255.255.0 broadcast 192.168.122.255 ether 52:54:00:93:1d:07 txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0 virbr0-nic: flags=4099<UP,BROADCAST,MULTICAST> mtu 1500 ether 52:54:00:93:1d:07 txqueuelen 1000 (Ethernet) RX packets 0 bytes 0 (0.0 B) RX errors 0 dropped 0 overruns 0 frame 0 TX packets 0 bytes 0 (0.0 B) TX errors 0 dropped 0 overruns 0 carrier 0 collisions 0