windows自動登入鎖定

Windows 10’s Creators Update adds Dynamic Lock, which tries to automatically lock your PC when you step away. Dynamic Lock uses Bluetooth to check the signal strength of your smartphone. If the signal drops to a certain level, Windows assumes you’ve walked away with your smartphone and locks your PC.

Windows 10的創作者更新添加了動態鎖定，該功能會在您離開時嘗試自動鎖定您的PC。 Dynamic Lock使用藍芽檢查智慧手機的訊號強度。 如果訊號下降到一定水平，則Windows會假定您已經離開智慧手機並鎖定了PC。

Where Windows Hello allows you to automatically unlock your PC with a , Dynamic Lock allows you to automatically lock your PC. This feature is reportedly known as “Windows Goodbye” internally at Microsoft. Once you’ve paired your phone with your PC using Bluetooth and enabled Dynamic Lock, all you have to do to lock your PC is walk away. Here’s how to get it set up.

Windows Hello允許您使用來自動解鎖PC，而Dynamic Lock可以使您自動鎖定PC。 據報道，此功能在Microsoft內部被稱為“ Windows再見”。 使用藍芽將手機與PC配對並啟用了動態鎖定後，鎖定PC所要做的就是走開。 這是設定方法。

將智慧手機與PC配對 (Pair Your Smartphone With Your PC)

Before you can enable Dynamic Lock, you’ll need to pair your smartphonewith your PC using Bluetooth. Dynamic Lockcan’t connect to your phone and check its Bluetooth signal strength unless you do.

在啟用動態鎖定之前，您需要使用Bluetooth將智慧手機與PC配對。 除非您這樣做，否則Dynamic Lock無法連線到您的手機並檢查其藍芽訊號強度。

Start by puttingyour smartphone into pairing mode. On an iPhone or Android, you can do this by heading to Settings > Bluetooth. While at this screen, if Bluetooth is on, your phone will be discoverable.

首先將智慧手機置於配對模式。 在iPhone或Android上，您可以轉到設定>藍芽來執行此操作。 在此螢幕上，如果打開了藍芽，則可以發現您的手機。

Next, start the pairing process on your Windows 10 PC. Head to Settings > Devices > Bluetooth & other devices, click “Add Bluetooth or other device”, and then click “Bluetooth” to pair a Bluetooth device with your PC. You’ll see your phone in the list if it’s discoverable, although it may take a few moments to appear. Click your phone and confirm that the PIN matches on both your phone and PC when prompted. You’ll be informed the pairing process is complete.

接下來，在Windows 10 PC上開始配對過程。 前往“設定”>“裝置”>“藍芽和其他裝置”，單擊“新增藍芽或其他裝置”，然後單擊“藍芽”以將藍芽裝置與PC配對。 如果可以發現手機，您會在列表中看到它，儘管可能需要一些時間才能出現。 單擊您的電話，並在出現提示時確認PIN在電話和PC上均匹配。 您將被告知配對過程已完成。

啟用動態鎖定 (Enable Dynamic Lock)

To enable Dynamic Lock, head to Settings > Accounts > Sign-in options, scroll down to the “Dynamic Lock” section, and check the “Allow Windows to detect when you’re away and automatically lock the device” option.

要啟用動態鎖定，請轉到“設定”>“帳戶”>“登入”選項，向下滾動到“動態鎖定”部分，然後選中“允許Windows檢測何時離開並自動鎖定裝置”選項。

If you can’t check the box, you probably haven’t paired your smartphone with your Windows 10 PC using Bluetooth yet.

如果無法選中該框，則可能您尚未通過藍芽將智慧手機與Windows 10 PC配對。

If you don’t see this option here at all, your Windows 10 PC probably hasn’t upgraded to the Creators Update yet.

如果您根本沒有在此處看到此選項，則您的Windows 10 PC可能尚未升級到Creators Update 。

Windows 10 doesn’t provide any other options for configuring dynamic lock here. There’s no way to choose whichBluetooth device Dynamic Lock relies on, although it should use your smartphone. Microsoft’sofficialdocumentation says that Dynamic Lock requires a paired smartphone, although the Settings app refers vaguely to “devices that are paired to your PC”.

Windows 10此處未提供用於配置動態鎖定的任何其他選項。 儘管應使用您的智慧手機，但無法選擇Dynamic Lock所依賴的藍芽裝置。 微軟的官方文件說，動態鎖定需要配對的智慧手機，儘管“設定”應用模糊地指“配對到您的PC的裝置”。

Dynamic Lock may also work with other devices like smartwatches, but don’t count on it. Microsoft doesn’t want Dynamic Lock to useBluetooth devices you may leave near your PC at all times, like mice and keyboards.

Dynamic Lock也可以與其他裝置(例如智慧手錶)一起使用，但不要指望它。 微軟不希望Dynamic Lock使用您可能始終留在PC附近的藍芽裝置，例如滑鼠和鍵盤。

使用動態鎖定 (Use Dynamic Lock)

Take your phone with you, step away from your computer, and it will automatically lock about a minute after you step out of range. Note that different devices have different signal strengths, so the exact distance you need to travel beforeyour PC locks will vary.

隨身攜帶手機，離開計算機，離開範圍後約一分鐘，它將自動鎖定。 請注意，不同的裝置具有不同的訊號強度，因此PC鎖鎖定之前需要經過的確切距離會有所不同。

Your PC will also lock itself a minute after you turn off Bluetooth on your phone. That’s because Windows can no longer see your phoneis nearby. Fortunately, waiting for a minute also helps prevent your PC from locking when you don’t want it to just because Bluetooth looses its signal for a few moments.

關閉手機上的藍芽一分鐘後，您的電腦也會自行鎖定。 這是因為Windows無法再看到您的手機在附近。 幸運的是，等待一分鐘還有助於防止您的PC在您不希望因為藍芽失去訊號一會兒而被鎖定時鎖定。

When you come back to your PC, you’ll have to sign into your PC manually—either by entering a password, providing a PIN, or using a Windows Hello sign-in method. Dynamic Lock doesn’t automatically unlock your PC when the Bluetooth device comes back within range.

返回PC時，您必須手動登入PC，方法是輸入密碼，提供PIN或使用Windows Hello登入方法。 當藍芽裝置恢復到正常範圍內時，動態鎖定不會自動為您的PC解鎖。

翻譯自: https://www.howtogeek.com/302225/how-to-use-dynamic-lock-to-automatically-lock-your-windows-10-pc/

windows自動登入鎖定