f you use 'create table as select' (CTAS)

CREATE TABLE new_table AS 
    SELECT * 
    FROM old_table

you automatically do adirect-path insertof the data. If you do an

INSERT INTO new_table AS 
    SELECT * 
    FROM old_table

you do aconventional insert. You have to use the APPEND-hint, if you want to do a direct path insert instead. So you have to do

INSERT /*+ APPEND */ INTO new_table AS 
    SELECT * 
    FROM old_table

to get a similar performance as in 'CREATE TABLE AS SELECT'.

How does the usual conventional insert work?

Oracle checks thefree listof the table for an already used block of the table segment that has still free space. If the block isn't in the buffer cache it is read into the buffer cache. Eventually this block is read back to the disk. During this process undo for the block is written (only a small amount of data is necessary here), data structures are updated, e.g. if necessary, the free list,that esides in the segment header and all these changes are written to the redo-buffer, too.

How does a direct-path insert work?

The process allocates space above thehigh water markof the table, that is, beyond the already used space. It writes the data directly to the disk, without using a buffer cache. And it is also written to the redo buffer. When the session is committed, the highwater mark is raised beyond the new written data and this data is now visible to other sessions.

How can I improve CTAS and direct-path inserts?

• You can create he tale in NOLOGGING mode, than no redo information is written. If you do this, you should make a backup of the tablespace that contains the table after the insert, otherwisse you can not recover the table if you need this.

• You can do the select in parallel

• You can do the insert in parallel

• If you have to maintain indexes and constraints or even triggers during an insert operation this can slow down your insert operation drastically. So you should avoid this and create indexes after the insert and maybe create constraints with novalidata.