GPON OLT ONU配置命令
阿新 • • 發佈:2019-02-13
GPON OLT ONU配置命令
首先配置OLT板子,
configure system max-lt-link-speed link-speed ten-gb 這ten-gb可以是twodotfive-gb或者其他值,但一定要比板子的speed要大。比如OLT板子是10G的,這裡要大於等於10.
configure equipment slot lt:1/1/1 planned-type fgxt-a 這裡是規定了插入該rack/shelf/slot的板卡型別
接下來就是對PON口的配置了,首先我們需要把admin的狀態啟起來
configure interface port pon:1/1/1/1 admin-up
然後就是對該PON口下聯的ONU進行配置了
configure equipment ontinterface 1/1/1/1/2 sernum xxxx sw-ver-pland noplanned voip-allowed enable 對rack 1, shelf 1, slot 1, port 1的第2個ONU進行配置。這裡應該是ONU –ID與serial number的繫結。
後面是對ONUcard的配置
configure equipment ont slot 1/1/1/1/2/1 planned-card-type10_100base plndnumdataports 4 plndnumvoiceports 0 admin-state up
這時候其實物理層的配置已經結束了,ONU已經可以註冊到OLT上了。
下面就是VLAN,logicalport和VLAN port的配置了。