1. 程式人生 > >樹莓派-可以適應顯示器的boot/config.txt配置

樹莓派-可以適應顯示器的boot/config.txt配置

#hdmi_edid_file=1
# uncomment if you get no picture on HDMI for a default "safe" mode
#hdmi_safe=1 
# uncomment this if your display has a black border of unused pixels visible
# and your display can output without overscan
disable_overscan=1 
# uncomment the following to adjust overscan. Use positive numbers if console
# goes off screen, and negative if there is too much border
#overscan_left=-30
#overscan_right=-30
#overscan_top=-30
#overscan_bottom=-30
# uncomment to force a console size. By default it will be display's size minus
# overscan.
#framebuffer_width=1280
#framebuffer_height=720
# uncomment if hdmi display is not detected and composite is being output
hdmi_force_hotplug=1
# uncomment to force a specific HDMI mode (this will force VGA)
hdmi_group=2
hdmi_mode=32
# uncomment to force a HDMI mode rather than DVI. This can make audio work in
# DMT (computer monitor) modes
hdmi_drive=2
# uncomment to increase signal to HDMI, if you have interference, blanking, or
# no display
config_hdmi_boost=4
# uncomment for composite PAL
#sdtv_mode=2
#uncomment to overclock the arm. 700 MHz is the default.
#arm_freq=800 
# for more options see http://elinux.org/RPi_config.txt
轉自:https://www.zhihu.com/question/28342848?answer_deleted_redirect=true