2.2 Electrostatic Discharge ESD

靜電釋放

The modules and accessories contain static-sensitive components. Electrostaticdischarge can cause internal defects and impair proper functioning in the devices.Observe the following rules when unpacking and handling the modules andaccessories. Please refer to IEC 61340-5-1 and IEC 61340-5-2.

模組和附件中含有靜電敏感器件。靜電放電會造成內部缺陷，損害裝置的正常功能。拆箱、搬運模組和配件時，請遵循以下原則。請參閱IEC 61340-5-1和IEC 61340-5-2。

• Touch an earthed object in order to discharge the electrostatic charging
• Wear a suitable earthed strap around your wrist.
• Do not touch connectors or pins on printed circuit boards.
• Do not touch any circuits inside the equipment.

• If possible, use a work place which is equipped with suitable an electrostatic
  discharge.

• When not in use, store the equipment in suitable static safe packaging material.

• Cover the unused connector with a dummy plug to protect it from being
  touched (ESD).

• 接觸接地的物體以釋放靜電.
• 手腕上戴上接地腕帶
• 不要觸控任何因算電路板上的聯結器和引腳
• 不要觸控裝置內的任何電路
• 儘可能使用配備有靜電釋放裝置的工作場所
• 裝置不使用時，放入靜電安全的包裝材料中
• 使用空塞覆蓋保護不使用的插頭

2.3 Installation

安裝

Professional installation of controllers, power supplies, accessories etc. is essentialfor proper function of the Freelance system

專業安裝控制器、電源、配件等等對確保freelance系統正常功能十分必要。

• Due to its construction (degree of protection IP 20) and the connectiontechnology, it is recommended to install, operate the devices only in anenclosed housing e.g. switch cabinet.

• For the preparation of the installation, please refer to the “dimensions” Sectionin the Mounting and Installation, manual. Drawings show the required space,minimum distance to adjacent devices and more.

• Check tightness of the DIN rail, modules, terminal units and at least the powerconnections at the various terminals

• Install the modules and accessories in a dry, dust free, non-corrosive room, andin such a way that it is not subject to shocks or vibrations.

• Ensure that the cooling of the process station is not hindered in any way. Theventilation slots on the upper and lower side of the module must not beobstructed by wires, cable ducts etc. and should always be clear

• 由於其結構(保護程度ip20)和連線技術，建議僅在封閉的外殼(如開關櫃)中安裝、操作裝置.
• 關於安裝的準備工作，請參閱《安裝與安裝手冊》中的“尺寸”部分。圖紙顯示所需的空間，最小距離相鄰裝置等
• 檢查DIN導軌、模組、端子和至少各端子上的電源連線是否緊固
• 請將模組和附件安裝在乾燥、無塵、無腐蝕、無衝擊、無振動的環境中.
• 確保工藝站的冷卻不受任何阻礙。模組上下兩側的通風槽不得被電線、電纜管道等堵塞，並應始終保持暢通